We've all been there. You spend years chasing tone — the right fuzz, the right reverb, the right delay that sits just where you want it. Then you open your DAW and track everything direct. Flat. Sterile. None of that gear ever makes it to tape. You might try to recreate with on board effects but something is just a bit off.

That's the problem we built the EL&R to solve.

The EL&R 500 started as a one-off. Something we built for ourselves so we could run pedals as rack effects, reamp dry tracks through an amp, and get transformer warmth into the signal path without a pile of adapters and ground loops. We built it, used it on every session, and never went back.

As is the case with most guitar gear and pedals, a few friends asked if we could build one for them. Then a few more. That's when we knew it was a real product.

We're a small operation by design. Each EL&R is assembled by hand and goes through a full test before it leaves the shop. That means we know every unit works exactly the way it should before it gets to you.

We use Cinemag transformers because they're the right choice, not the cheap one. We run regulated DC outputs because wall warts and daisy chains are a headache nobody needs. We built the impedance matching in because getting that wrong changes the tone.

The goal is simple: build gear that works exactly the way you need it to, ships in a few days, and holds up for years.

Boutique Amplifiers and Recording Gear.

417 Renau Blvd.
Summerville, SC 29483
615.208.9995

New products, studio tips, and the occasional giveaway. No fluff